cuts for felling a tree

Omit this step if the tree is small enough for the saw bar to reach through the tree in one cut. With the tree on your left and your left shoulder against the tree make a 70-degree cut on the side facing the direction you want the tree to fall.

Take Down A Tree Extreme How To

When using a chainsaw irrespective of if youre using it for bucking climbing felling trees or cutting branches youre required to wear these protective gear.

. Plastic wedges and a STIHL axe built for felling are vital to maximizing the efficiency of your felling operation. Keep adding more wedges as necessary. Once the front notch is cut you can then make the back cut with your chainsaw.

Anything larger than this should only be felled by a trained and competent person. In this video Inbred Jed and myself demonstrate 8 different ways to drop a tree and the different applications of the different cutting techniqueswe go over. There are 3 tree notch cuts commonly used in tree-felling.

The tree ensuring that the two boring cuts meet. Be Ready As your back cut is completed you should end up with an even holding wood. The easiest choice is to fell the tree in.

Face Cuts Back Cuts and Fish StoriesIn this episode we let the new guy Tom cut down his first t. There are certain circumstances for using each. Decide which direction you want the tree to fall and make a felling mark to show where your top cut will start.

If youre felling a tree thats more than 18 in. Treefelling treefalling treeworkTree Felling Basics. The procedure described below is suitable for trunks up to about 200mm 8 diameter at the base.

They are the open-face notch the conventional notch and the Humboldt notch. Cutting a tree down is safely getting the upright tree on the ground in a safe manner. Be sure you are not hemmed in with underbrush or.

Either that or the tree will begin to fall. Plastic wedges are far. Make sure to use plastic wedges as opposed to metal.

A final horizontal back-cut is made below the. Stop cutting as soon as youve penetrated far enough to. The notch created by the top and bottom cuts in the picture above is called an Open-face Notch You can compare this notch with the Humbolt and Conventional Notches.

The easiest choice is to fell the tree in the direction it would naturally fall due to slope overhang and wind direction. Around the tree before starting to cut. Be ready to run at.

The back cut is what disconnects the tree from the stump and creates a hinge for the tree to fall. Make your top cut downwards towards the stump height mark at. In diameter go ahead and make your notch cut and begin the felling cut.

Felling in another direction requires a special technique.

Technical Tree Cutting And Felling North American Training Solutions